preparation of inside of centreboard case

Ask an Expert !
Do you have a question about any aspect of YM designed boats?

Moderators: Eventide Owners Group, Piskie, chris s

john burke
Posts: 17
Joined: Sat August 4th, 2007, 11:41 pm

preparation of inside of centreboard case

Postby john burke » Fri May 15th, 2009, 8:16 pm

I am currantly reassembling the centreboard case on my three tonner and need to treat and paint the timber before it is all sealed up. What is the best paint for this job? I was thinking of using red lead paint but it;s hard to obtain. I was advised to use a mixture of white spirit and boiled linseed oil mixed with red lead powder. I have all these ingredients but I'm not sure of the ratios. Any advice welcomed.

chris s
Posts: 135
Joined: Sun March 5th, 2006, 6:55 pm
Location: Netherlands

Postby chris s » Sun May 17th, 2009, 3:34 pm


Len
Posts: 23
Joined: Wed September 27th, 2006, 1:06 pm
Location: Kösching, Germany

Postby Len » Sat May 23rd, 2009, 1:15 pm

Hi John,

A suggestion I like is to line the CB case with "formika" (?). Gleu it in place with epoxy. This came (I think) from Iain Oughtred) and is what I will do.

In one of his books MG suggests filling the case with old engine oil and letting it drain out with the tide !!! Better not. Especially not here in Germany,.

Grüße
Len
Leonard_Woods


Return to “HELP ?”

Who is online

Users browsing this forum: No registered users and 1 guest